Item Number

Q007

Q007 Ground Adapter Plug

This new dual socket Grounding Cube provides an ESD ground path to a previously tested receptacle

• Provides two banana jack grounding ports
• Easy access grounding ports regardless of outlet orientation
• Low Cost
• Non-Flammable ABS plastic
• Currently available

Dimensions:

Length: 1.25" (3.175 cm)
Width: 1.00" (2.54 cm)
Height: 1.25" (2.54 cm)

Pre-test Outlets

Prior To installation, always test the electrical outlet in accordance with AN SI/ESD S6.1 Grounding Standard to insure ¹:

• The ground conductor is present
?
• There are no electrical shorts to the ground conductor
?
• The electrical outlet is properly wired
?
• Ground conductor impedance to the distribution panel is less than 1 ohm

¹This circuit test is easily perform ed with a PGT-161 SureTest Circuit Analyzer available from Prostat and other sources.

U se the Prostat Qube for Resistance to Ground (RTG)M easurem ents as required by Industry Standards such as ANSI/ESD S20.20 and IEC61340-5-1 S

PRF-911BNC-BNC Adapter for PRF-911

Dual Plug, BNC Adapter for use with the PRF-911 Concentric Ring Fixture

Dimensions:

PRF-912AL Adapter Lead

The PRF-912AL Adapter Lead with BNC Adapter for use with the PRF-912 Miniature Concentric Ring, PSI-870 Resistance/Resistivity Meter and other resistance measuring test equipment.

Item Number:
PRF-922A

PRF-922A Miniature Two-Point Probe Adapter

The PRF-922A Miniature Probe Two Point Adapter, allows Prostat customers to convert their PRF-912, or PRF-914 Miniature Concentric Ring "Micro Probes" to a precision "two point probe". The PRF-922A Adapter is configured to simply slide onto the PRF-912 & PRF-914 fixtures and use their gold plated concentric ring pins for direct contact with the Adapter's 2-point measurement assembly. Having both Concentric and 2-point fixtures provides maximum flexibility for measuring small areas and parts. Includes built-in stops and conductive electrodes covers.

SPECIFICATIONS:

Item Number:
PRF-MR

PRF-MR Micro Probe Adapter Rings - Set of 5

In today's material technologies, many different types of composites are used to achieve electrostatic control. Combinations of various conductive ingredients, such as carbon, powdered metal or fibers, are blended with insulative materials to obtain static dissipative characteristics. Often the electrical surface characteristics of these compounds vary due to the distribution of conductive additives, mold design, the thermal forming process, or material properties. Consequently, material surface resistance will vary depending on fixture contact resistance, the surface characteristics of the primary material and distribution of the conductive additives.

The PROSTAT PRF-MR Micro Probe Ring Adapter Set is designed to minimize contact resistance and irregularities in measuring these unique materials when using the PROSTAT PRF-912 and PRF-914 Miniature Concentric Ring Fixtures. The adapters are installed over the contact surfaces of the miniature concentric ring electrodes.

PRS-801 CC Calibration Shunt

The PRS-801 CC is a 1 ohm calibration reference for use with the PRS-801 Resistance System Set and PRS-812 Resistance Meter Set.