Call Today to Order
UltraStat Original Dry Adhesive
UltraStat® Original Dry
Adhesive is a full
surface textile re-enforced double sided self stick roll flooring
It is VOC free, free of
out-gassing and is totally safe for people. The adhesive is acrylic
based, plasticizer resistant, contains no formaldehydes and has unrestricted
waste disposal. UltraStat® has a lower adhesive strength to the
old flooring and a high strength adhesion to the new flooring. Installations
(i.e. carpet tile over access floors, trenches, or old carpet) are
releasable. (See restrictions in detailed installation instructions).
7700-100025 Rolls 39.5" x 82'6" (1 m x 25 m)
7700-50025 Rolls 19.5" x 82'6" (50 cm x 25 m
UltraStat® may be installed only over dry (<3.0 lb/1000
sft.) structurally sound firm dust and oil-free surfaces, such
as concrete, old glue-down carpet, VAT, vinyl composition tile,
homogeneous vinyl sheet or tile, poured epoxy, ceramic, stone
or terrazzo. It may be used over steel or HPL covered access
floors. It may be used over wood and parquet, plywood and laminates
only if these sub-floors are free of acrylic finishes and are
not directly installed over on-grade or below-grade concrete
without an air space between the concrete and the wood products
(Moisture!!). Dry adhesive may not be used over gypsum patches.
Not suitable for outdoor installations.
Ultra® may be used to adhere carpet with jute, Action Bac®,
SBR foam back, Unibond and carpet tile with glass fiber reinforced
vinyl backings or bituminous backings. It is also used to install
solid vinyl sheet or tile.
Unsuitable New Flooring:
Dimensionally non-stable flooring products, rubber sheet or tile,
vinyl composition tile (dusty back), wood or laminate floors,
cork, cocos are not suitable. Certain recycled rubber flooring
has limited suitability. Recycled EPDM based rubber is not
Advantages of Installation
with Ultra® Dry
Save the dust, debris, expense of disposal of old flooring and
re-prepping of old sub-floors necessitated by tear out. Dry
adhesive has no open time. It can be laid directly over old
floors. Vinyl may be heat welded immediately. Installations
may be subjected to rolling loads and heavy traffic without
Roll out Ultra® perpendicular to new
flooring. Overlap and double cut seams.
For carpet over carpet use Ultraconstruction
tape to re-enforce perimeters
and seams beneath the Ultra®.
Unroll new carpet or vinyl,
seam seal as per manufacturer's specifications.
Roll and put into service.
conduct tests before
Original Dry Adhesive Data Sheet