Skip to page content
Ground Zero Electrostatics Logo
Leader in Static Safe Solutions for High Tech Industries
Explore our ESD Flooring and Static Control Products for your ESD needs:
Call 877-463-9376 for a FREE Consultation!
ESD Grounding   Ground Zero
ESD and Static Control Flooring - Carpet, Vinyl Tile, Epoxy Floors, Rubber Flooring
Static Control & ESD Vinyl Tile [Home]

PolyStat Static Control Premium Sheet Form / Welded Vinyl Flooring
ESD vinyl Tile
Physical Specifications:
  • Gauge: 0.080 in. (2.0 mm)
  • Sheet Width: 6.561 ft. (2m)
  • Sheet Length: 65.616 ft. (20m)
  • Roll Size: 6ft 6in x 65ft =47 sq yds
    (2m x 20m=40 m2)
  • Weight: 6.45lbs/sq yd (3.50 kg/m2)
  • Tile Size: 23.9 x 23.9in.
    (608 mm x 608 mm)

Flame Spread and Smoke Emissions:

  • BS; 476 Part 7, 1987: Class 2
  • Din 4102: B1
  • ASTM E648: Class 1
  • AS 1530.3: Flame Spread 0

Light Fastness: >7 In Use Area Classification per EN 685: 34/43

Features:

  • Popular Designer Colors
  • Options in Conductivity
  • Roll goods or Tiles
  • Outstanding longevity
  • Low (to no) maintenance
  • High shine or low glare finish
Electrical Resistance: PolyStat Static Conductive
  • PTP: 5.1 x 104 to 2.5 x 106 @ 10 Volts
  • RTG: 5.1 x 104 to 2.5 x 106 @ 10 Volts

Electrical Resistance: PolyStat Static Dissipative:

  • PTP: 1.1 x 107 to 5.5 x 109 @ 100 Volts*
  • RTG: 1.1 x 106 to 8.5 x 108 @ 100 Volts*
  • Abrasion Resistance: EN 649: 1996, Group P

Chemical Resistance: PolyStat has good resistance to dilute acids and alkalis. Chemical resistance charts by shade are available on request

Installation Adhesives: GZ-C2000 or URAS conductive releasable adhesive only.

Static load limit: Per ASTM F-970
Navigation
Technical Documents
Free Samples
Free Estimate
Which ESD flooring is best for you?  Use the ESD Flooring Selection Chart to find out.
adobeAdobe Acrobat Required
Facility Testing

As is the case with many of the modern ESD Vinyls, PolyStat is designed to work as a system in conjunction with GZ-C2000 or URAS conductive adhesive. When testing uninstalled, static dissipative material (without the adhesive) PolyStat SD will show a slightly higher resistance value than those posted in our electrical specifications (prevalent only with the static dissipative materials). PolyStat static dissipative is designed with a built in resistance value that provides added safety to employees that may come into contact with higher voltage / amperage power sources. This added resistance has shown minimal effect in it's ability to drain ESD potential.

Information below shows our actual "real life" test results after installation at two Facilities (both approximately 70,000 sq/ft each) in separate parts of the Country (one in Mexico, one in California). Testing was performed in accordance with industry accepted standards of EOS ESD 7.1. These floors were installed "on grade" and on cement. Further, the floors were grounded utilizing the advanced parameters shown in How to Ground your new ESD Floor. Your results may vary due to substrate, substrate conditions and environmental conditions prevalent at the testing location.

Extended Electrical Testing by Ground Zero Electrostatics, Inc:
Conductive
*Tested at a relative humidity > 30%.
dissipative
Maintenance:
Maintenance is dependant on the nature and intensity of traffic and the specific requirements of the end user. To keep cost low, without compromising standards of hygiene and cleanliness, Ground Zero Electrostatics, Inc recommends that a maintenance regime be specifically tailored to your needs. Polishes or floor finishes that inhibit the floors electrical performance must not be used. Remove abrasives by sweeping on a regular basis. Damp mop with warm water and approved Ground Zero Electrostatics, Inc ESD Cleaning solution as needed. A clean floor insures consistent electrical performance. PolyStat ESD Vinyl is initially supplied with a non-glare finish. If your needs require a high shine, simply burnish the material with a high speed floor buffing machine. Contact Ground Zero Electrostatics, Inc for further recommendations.

arrow PolyStat - Overview
PolyStat - Specifications
PolyStat - Design/Colors
 arrow